AcquaTint™ Water-Based Colored Sealer.
It lasts a lot longer than paint, can be recoated and it’s semi-transparent, so the character of your concrete lives on.
BeforeAfter
BeforeAfter“Easy to apply, clean up and made a huge impact as far as looking like it did when we built the house!”
“Amazing product and very easy to use. Just make sure that your concrete doesn’t have any previous coatings.”
Bring color back to a faded patio or give that plain gray basement floor some character. AcquaTint™ is a low-odor tinted concrete sealer that adds lasting color indoors and out.
99/100
Top rating9 chemicals tested
AcquaTint™ is made on our top-performing sealer formula, which earned 99/100 when tested against these chemicals:
From soft grays to deep, rich tones. Tap a color to see it on a real customer floor.
Two thin coats, and it’s ready for light foot traffic in 1 to 2 hours.
For patios, walkways and garages. 1 gallon covers about 200 sq ft at two coats; 5 gallons about 1,000 sq ft.
For indoor floors
1 gallon AcquaTint™ + 1 gallon ProWax Polish™, about 200 sq ft, with wax left for two maintenance coats. The wax takes the foot traffic, so your color doesn’t.
5 gallons AcquaTint™ + 5 gallons ProWax Polish™. One batch keeps the color consistent across the whole floor.
No. AcquaTint™ needs bare, clean concrete. Sprinkle some water on it: if the water beads, there’s a sealer to strip first.
Do the same water test. If the water sits on top instead of soaking in, the surface is too closed: open it with CitrusEtch™ first.
Yes. It goes on milky and dries to the color.
Yes. Roll thin coats with a 3/8" nap, then backroll so there are no lap lines. The how-to shows each pass.
Every slab takes color its own way, so every result is unique. Test a small spot first, or start with the Trial System.
Both. Indoors, finish with ProWax Polish™. Outdoors, AcquaTint™ goes on its own.
The AcquaTint™ Trial System has 3 colors of your choice in sample sizes and 3 foam brushes, so you can see each one on your actual concrete. It’s the same AcquaTint™ as the full size. Free shipping.
Every order includes a free project consultation. Questions? Call us at (877) 255-2656.
Water-basedMade in the USAFree shipping on Trial Kits
EasyTint™ and OxiGrip™ are not compatible when used together directly. For slip resistance, use EasyTint™ as the color layer and apply OxiGrip™ only with a clear solvent based sealer as the topcoat.
AcquaTint™ and OxiGrip™ are not compatible when used together directly. If you need added slip resistance, apply AcquaTint™ as your color layer first, then use OxiGrip™ in a clear topcoat with AcquaSeal™ or HydroCryl™.
Your cart contains AcquaTint™ or EasyTint™ and a sprayer that isn’t suitable for applying it. If you plan to spray your tinted sealer, use a sprayer with a fan tip.
Please remove this sprayer unless you need it for another compatible product.