FREE Shipping on Trial Kits

Specifications – Trial Kit - AcquaTint™

AcquaTint™ Trial System — Specifications
Location Suitable for both interior and exterior surfaces.
Application Tools Foam brush applicators (included). Apply with very light pressure to avoid streaking.
Number of Coats 2 thin coats, applied in the same direction, to match the full-size finish.
Coverage Each 4 oz trial size covers approximately 6 sq. ft. at two coats, varying by surface condition.
Dry & Cure Times Dry to touch in 30–60 minutes. Wait at least 2 hours between coats. Foot traffic after 6–12 hours; fully cured at 24 hours.
Application Temperature For optimal results, apply between 60°F–95°F (15°C–35°C).
Recommended Top Coats For enhanced durability and finish, this colored sealer is compatible with AcquaSeal™ or HydroCryl™ Water-based Acrylic Sealer, and ProWax Polish™ for interior floors.
Removing a Test Spot Changed your mind after testing? Strip the colored sealer with Destiny™ Stripper, then neutralize with ProClean Neutralizer™ and rinse. On porous concrete, some tint may remain; lightly etch or abrade to reduce it further.
Important Note Prevent freezing to maintain product effectiveness.

Before You Checkout

EasyTint™ and OxiGrip™ are not compatible when used together directly. For slip resistance, use EasyTint™ as the color layer and apply OxiGrip™ only with a clear solvent based sealer as the topcoat.

Before You Checkout

AcquaTint™ and OxiGrip™ are not compatible when used together directly. If you need added slip resistance, apply AcquaTint™ as your color layer first, then use OxiGrip™ in a clear topcoat with AcquaSeal™ or HydroCryl™.