EasyTint™ Colored Sealer

DECORATIVE CONCRETE SEALER AND STAIN

COLOURED CONCRETE SEALER

TINTED SEALER APPLICATION

Tinted Solvent-Based Sealers are best applied using a pump-up fence and deck sprayer using the red tip. Attempting to roll a clear coat may cause color lift and streaking.

Tinted Water-Based Sealer should be applied with a pump-updeck sprayer and can be back rolled with a fully saturated de-fuzzed 3/8″ nap roller. Keep the roller evenly and consistently loaded with sealer at all times during application to avoid roller marks and streaking.

DO NOT apply Water-Based Sealer if the surface temperature is under 60°F with an air temperature difference of 5 degrees or less. Central heating, radiant or convection heaters, or similar heating devices should be turned off during application. In-floor heating should be set at 60-65 degrees before and turned off during the application process. Do not allow to freeze.

CLEAR CONCRETE SEALER TOP COAT

•  Outdoor concrete requires two tinted sealer coats and one clear sealer coat for added durability and more even wearing over time.

• The clear top coat should be reapplied once every two years for most outdoor areas.

• Indoor floors should be waxed after applying two tinted sealer coats.

• Concrete wax should be reapplied over the life of the floors as often as needed to protect the underlying sealer.

STAMPED CONCRETE SEALER APPLICATION

Sealers should be applied with either a pump-up sprayer or a short-nap roller (approximately 3/8″) or less. For best results with a roller, use the pan grid to purge the roller of all excess sealer and apply with slow, even strokes. Sealer bubbles, should they occur, can be removed with a hair dryer set to cool or a clean leaf blower set to low speed.

All Direct Colors Tinted Concrete Sealer products must be shaken well before and during use to insure even pigment distribution during application.

Generally, the thinner the application, the stronger and more durable the sealer will become. Applying a thick coat will result in an inconsistent finish with tacky areas that may not set-up correctly. Allow solvent-based sealers to dry for AT LEAST 4-6 hours between coats. Water-based sealers should be given up to 24 hours to set-up between coats. If you live in a humid climate or the weather conditions are damp and overcast, give the surface additional time to dry.

DO NOT walk on wet sealer as it will leave permanent impressions on your surface. Cover your feet with plastic bags to protect your floor's finish during application.

Indoor applications require either a commercial or residential wax to protect your sealer from daily wear and tear.

Concrete Wax and Floor Polish products are water-based and should be applied using a mop with a hand wringer or with the applicator of your choice.

Commercial wax intended for business use or for homes with indoor dogs and should be buffed after the initial application.

Note: As a made to order product there are no refunds, exchanges or returns.